Plumber?

Solutions


	Emergency Tradesmen Plumbing & Drains Plans

Sponsors

British Gas


	Plumbing & Drains

Dynorod


	Drains Services Plumbing Emergency Plumbing Installation

Drains Guides


	Cleansing Impeded Drainage The Supreme Repair for a Choked up Kitchen Sink The Perfect Repair for a Stopped Kitchen Sink Sanitising a Obstructed Sink Waste Pipe Cleansing a Choked up Sink Waste Pipe Stopped Drain Pipe Repair You Can Empty a Stopped Bath Room Waste Pipe Freeing Obstructed Manholes and Drainage Pipes

Plumbing Guides


	Cleansing Choked up Drainage Purifying a Clogged Sink Waste Pipe Why Do You Demand a Waste Pipe Purifying Service? The Preferred Repair for a Obstructed Kitchen Sink You Can Empty a Obstructed Bath Room Drain Pipe

Search Site


	Plumber? @ moms for the holidays…she has 1/2inch PVC from water heater to lavatory, hot and cold, both 1/2 inch pvc fittings to valves are cross threaded, instead of replacing the PVC fittings I want to sweat copper from water heater, and cold feed to lavatory what fitting do I need to go from PVC to copper thread? or should I just cut the pvc where it is cross threaded and replace the 1/2inch slip joint to thread fitting? 2 Responses to “Plumber?” Sierra Hazlehurst Said: 1/2″ male PVC thread and a 1/2″ female copper Glue the PVC and then thread on the copper and go from there. Breanna Brooker Said: You can also use a compression coupling, 5/8″ OD.Or you could use a ball valve with the same compression fittings on each end. If you choose this method of repair, be sur eto use a little pipe joint compund on ferrels and threads of compression fittings.It makes them tighten much easier.Also be sure not to over tighten end that cpvc goes in to. Good luck. Leave a Reply You must be logged in to post a comment. Posted in Questions Similar Posts you may be interested in ... How do I sweat a ball-valve into my copper plumbing without damaging the valve seal? I bought a ball valve that is designed to be sweat (soldered) into my copper plumbing, but won’t the heat from the soldering process damage the seal around the ball valve? How does one avoid that? How do I keep sediment from clogging my plumbing fixtures? I have fairly new copper plumbing and a two year old tankless water heater and I am having a problem with a sediment containing black, white and grey particals cloging my shower head and my bath tub filler. I even had to clean out the hot valve itself on the bath tub. I have allready What to do with water heater and water softner when draining water from plumbing? Hello! I may have a problem with water hammer or pockets of air or whatever in my plumbing system. In order to troubleshoot, I want to drain the water from the pipes for the whole house and then refill it. What should I do with the water in water heater and water Why are water storage tanks made out of stainless steel yet the plumbing in the home is copper? If you are trying to buy a metal tank for storing potable water then it will almost alway be made out of stainless steel. However, when it comes to plumbing with metal you are normally going to see copper. As a side not it seems like breweries as well as whiskey, scotch and bourbon distilleries Radiator Problems If you have a problem with one or more radiators in your home there are some investigative actions you take before calling in assistance from your home emergency plan company, or telephoning the local emergency plumber if you have not taken out a plan in advance. The actions that you take will depend upon whether the